Proper Use; For Safe Operation; Safety Information; Danger Of Electric Shock - Led2Work Systemled Evo Pir Betriebsanleitung

1 | Proper use

The light is used for illumination. A continuous operation is admissible. For connection values, see luminaire label and/or
"Technical data". The light is compatible with the common system workstations. The power connection is made via Wie-
land GST 18 plug and cable or from an other light via electrical interlinking. The power supply unit is built into the light.

2 | For safe operation

The operating parameters of the LED light specified on the type plate must correspond to the supply parameters of the
connection.
Operate the light only in a mounted status.

3 | Safety information

12 | BA SYSTEMLED EVO PIR . BA 08/2025
The safety information and all other information in this manual must be followed. Read
the entire operating manual carefully before mounting and turning on.
Under no circumstances may the light be covered with cloths, foils or similar. Object
distance the light-emitting surface should be at least 10 cm (3.94").
During the operation of the light in a 120-277V AC power supply net, it could be the
cause, that machines (induction perpetrators) inside the same power supply net cause
interference spikes at start.
Installation of electrical equipment may only be carried out by qualified electricians.
Follow the five safety rules according to DIN VDE 0105. Failure to do so may result
in damage to the LED light, as well as fire or other hazards.

Danger of electric shock!

Disconnect before working on the device or load. Ensure to disconnect all circuit breakers
that supply dangerous voltages to the device or load, when doing so. Even when the
device is switched off, the load is not galvanically isolated from the mains.
Only use the device if it is completely free of faults, and with safety and awareness in
mind. If warnings or symbols are attached to the light, they must not be removed.