Safety Warnings - Pni Rc800 Bedienungsanleitung

Safety warnings

Use the remote control only when you have full visibility of the gate.
Do not leave the remote control within reach of children.
Do not use the remote control from a moving vehicle.
Do not modify or repair the remote control yourself.
Periodically check the operation of the remote control and the battery status.
Keep the remote control away from sources of excessive humidity or heat.
Premote control pairing procedure with the PNI AP800C system
Press the LEARN button on the main board. The LED will blink for 10 seconds. During
this time, press any key on the remote control. If the code has been learned, the LED will
blink twice. The remote control is now paired.
If no button is pressed, the LED will turn off after 10 seconds and the system will
automatically exit learning mode.
Hold down the LEARN button for 6 seconds, the LED will blink, release the button. Now,
all the codes that have been memorized have been deleted.
The system can learn a maximum of 20 remote controls. If you try to pair more than that,
the LED will blink 5 times to confirm that the maximum number of remote controls has
been reached.
During the remote control learning process, if you press button 1 or button 2 on the
remote control, then button 1 will control the gate in "in-car" mode: open-stop-close,
and button 2 will operate the gate in "pedestrian" mode. Buttons 3 and 4 have no function.
In the remote control learning process, if you press button 3 or button 4 on the remote
control, then button 3 will control the gate in "in-car" mode: open-stop-close, and button
4 will operate the gate in "pedestrian" mode.
In this way, you can pair the same remote control with 2 automation systems.
User manual 3 English