Troubleshooting Guide - Vogel's Rise 2000 Direct Control Produkthandbuch

OPERATING FUNCTIONALITY RISE
FUNCTION
Going up
Going down
Reset system
Hard System Reset
TROUBLE SHOOTING GUIDE:
1. Check whether all cables are still connected (power cable, DirectControl cable, gyroscope and motor cables)
2. Check which color the indicator light blinks:
a. Green: Active
b. Orange blinking: Calibrating
c. Red: Reset/error
3. If there is no object obstructing the li (anymore), run a system reset.
4. If a System Reset, doesn't solve it, try to run a hard reset.
5. Contact Vogel's
25
RISE 2000
DIRECT CONTROL
REQUIRED ACTION
PUSH DISPLAY UP
PULL DISPLAY DOWN
1. Move system to lowest position (if possible). If not, start with point 2.
2. Pull display down and hold at least 10 seconds, indicator LED will become red.
3. Release display and pull again until system gives visual feedback reset
is finished.
4. In case of a set bottom limit, li will go 'up' a er finishing reset up to the set limit.
5. Indicator LED will become green.
1. Unplug power cable, and all motor cables for 30 seconds. Then connect all
cables again.
2. Move system to lowest position (if possible). If not, start with point 2 (Reset system).
3. Pull display and hold at least 10 seconds, indicator LED starts to blink orange.
4. Release display and pull again until system gives visual feedback reset is finished.
5. In case of a set bottom limit, li will go 'up' a er finishing reset up to the set limit.
6. Indicator LED will become green.
CAUTION DURING RESET:
IF ONLY ONE COLUMN MOVES DURING RESET, STOP IMMEDIATELY AND CONTACT VOGEL'S
User Instructions