Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The cycle tune-up must be performed at initial installation of the indoor cycle for optimal performance and
longevity. Please read and follow all instructions below. If the indoor cycle is not installed and tuned as
described, components may wear excessively and the indoor cycle may become damaged. If you have
questions about the installation, please contact service@indoorcycling.com.
Note: Some maintenance procedures require WD-40 (refillable spray bottle recommended) or Brunox spray
lubricant, and White Lithium grease.
1.
Make sure that the indoor cycle is level. If the indoor cycle rocks on the floor, turn the
leveling feet underneath the front and/or rear stabilizer until the rocking motion is eliminated.
2.
Verify Emergency brake function to assure that emergency brake functions correctly.
3.
Brake pad calibration: Turn resistance knob counterclockwise as far as possible (minimum bra-
king effect), verify that there is a slight separation of the brake pad from flywheel. Brake pad
should barely touch the flywheel when resistance knob is turned counter-clockwise as far as it
can go.
4.
Apply WD40 or Brunox spray lubricant to the brake pad using the lubrication holes on the plastic
part or the brake pad and externally on the felt pad. Make sure brake pad is thoroughly soaked
from end to end with lubricant spray. Then, wipe the excess off from the flywheel.
* Best Practice: Use a refillable spray bottle filled with non-aerosol WD-40 purchased by the
gallon (3.7 L) at the local hardware store.
5.
Apply Lithium grease to the threads on the lower end of the brake rod. First, turn the Resistance
knob clockwise until it stops. Apply a small amount of white lithium grease to the threads on the
brake rod above the two lock nuts. Then, turn the resistance knob counter-clockwise until it stops.
6.
Apply Lithium grease on the metal threads of all the adjustment knobs.
7.
Verify four (4) Allen nuts on RS pulley for tightness. If loose, apply LocTite Threadlocker Blue-242
and retighten.
8.
Verify R and L crank arm Allen bolts for tightness. If loose, apply LocTite Threadlocker Blue-242
and retighten.
9.
Verify belt tension. Check if belt drive is firmly tightened and does not slip while riding under resis-
tance load. In case that the belt slips, proceed using the adjustment technique as described on
page (28). Please note that a belt drive gear never shows slack. In case of adjustment do
not apply too much tension.
10.
Wipe down bike frame with rag moistened with WD-40
11.
Some parts of the indoor cycle may become loose during shipment. Check crank arms, check all
exposed screws, bolts, and nuts, and make sure that they are properly tightened.
12.
(S Series in the U.S.A. only) Verify that computer is reset for Miles vs. Kilometers and RPM mea
surement is working properly. Please see computer manual for instructions on installation of com
puter.
Customer Service
1.
Provide basic maintenance instructions to client and direct them to detailed maintenance instruc-
tions starting at page 24.
2.
Sign-off sheet provided to client to confirm explanation of maintenance procedures/manual and
verification of condition of bikes?
Version 1.1 2010 SB and 2010 TLS Copyright by Indoorcycling Group GmbH | www.indoorcycling.com
INITIAL INSTALL CHECKS
ENG 19
Werbung
Inhaltsverzeichnis
