Weka FRIDA WS75 Betriebsanleitung Seite 21

6.2 Electric
The saw motor can not be started.
Longitudinal and dip feed are
exchanged.
The saw switches off completely.
7. M A I N T E N A N C E
ATTENTION: Always remove the mains plug from the supply socket before starting maintenance
or repair!
Clean the machine once the sawing work has been completed.
You can sprinkle the support carefully with a soft jet of water.
Never use a high pressure cleaner or even a steam cleaner.
The control system box may only be cleaned with a dry or moist cloth.
Damaged cords and plugs have to be repaired or exchanged exclusively in an authorized repair station
(www.weka-elektrowerkzeuge.de).
If water runs out of the overflow-hole on the case top [19] or the disc [26] or on a different place except the
spindle, stop the machine immediately and let it be repaired in an expert workshop.
The same is valid for the gear oil.
If the sawing support on the guide-way has too much clearance, it is to correct as follows:
Loosen hexagon nut [27], twist eccentric bushing [28] until the clearance is corrected. Then refasten the
hexagon nut [27].
Let the water completely flow out of the system especially in the cold seasons - Danger of frost!
8. G U A R A N T E E
We will guarantee the WEKA wall saw for 12 months from the day of delivery. During this period we will
rectify material and production defects free of charge. This warranty does not cover normal wear and tear,
overloading, non-compliance with the operating instructions and intervention by unauthorized persons or
the use of parts from other companies.
9. D E C L A R A T I O N O F C O N F O R M I T Y
Description: Diamond wall saw - for cutting concrete, stone and masonry
Type: WS75, WS75H (and versions)
from serial no.: 0110001
We hereby declare under our sole responsibility that this product conforms with the following standards:
EN60204-1, EN 55014-1, EN55014-2, EN61000-3-2, EN61000-3-3 in accordance to the regulations of
directive 2006/42/EG and 2004/108/EG.
WEKA Elektrowerkzeuge
Auf der Höhe 20
D 75387 Neubulach
10. R E C Y C L I N G
According to the European regulation 2002/96/EG we have to take back old machines for
departing them by substance and for recycling (see sign on name plate). Please make sure that
the old tool does not get into the unsorted municipal solid waste, but that they are given back
to us, resp. abroad to our distributors.
The green LED light doesn't show. s. 3.6.
Both motor wires are exchanged (crossed).
The saw motor has been overloaded.
One or more phases have failed (green LED) s. 3.6
Neubulach, 29.12.2009
Wilhelm Wurster, Owner
Übersetzung der Originalbetriebsanleitung - Subject to change without notice 0510
20