Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
c)
Avoid unintended start up. Make sure that the electric tool is switched off before
connecting it to the mains and/or the battery, picking it up or carrying it. When you
have your finger on the switch while carrying the electric tool or connect the device to the
mains when it is switched on, this can cause accidents.
d)
Remove adjusting tools or wrenches before switching on the electric tool. A tool or
wrench which is located on a turning device can cause injuries.
e)
Avoid abnormal posture. Care for safe standing and keep the balance anytime. Do not
work on a ladder. Thus you can control the electric tool better in unexpected situations.
f)
Wear suitable clothing. Do not wear wide clothing or jewelry. Keep hair, clothing and
gloves away from moving parts. Wide clothing, jewelry or long hair can be caught by
moving parts.
g)
If there is the possibility to assemble a dust exhauster and collecting device, make
sure that these are connected and used correctly. The use of a dust exhauster can
reduce dangers by dust.
4)
Use and handling of the electric tool
a)
Do not overload the device. Use the appropriate electric tool for your work. With the
appropriate electric tool you work better and saver in the declared range of performance.
b)
Do not use an electric tool whose switch is damaged. An electric tool which can not be
switched on and off is dangerous and has to be repaired.
c)
Unplug the plug from the socket and/or remove the battery before carrying out
instrument settings, exchanging accessories or put the device aside. This safety
measure avoids the unintended start of the electric tool.
d)
Keep unused electric tools out of reach of children. Do not allow persons to use the
device who are not familiar with it or have not read these instructions. Electric tools are
dangerous if they are used by inexperienced persons.
e)
Maintain electric tools with care. Check if movable parts function correctly and do not
jam, if parts are broken or damaged in that way, that the function of the electric tool
affected. Have damaged parts repaired before using the device. Many accidents
originate from bad maintained electric tools.
f)
Keep the cutting tool sharp and clean. Carefully maintained cutting tools with sharp edges
do jam less and are easier to guide.
g)
Use electric tool, accessory, operation tools, etc. according to these instructions.
Thereby consider the conditions of employment and the work to be done. The use of
electric tools for others than the intended task can result in dangerous situations.
5)
Service
a)
Have your tool only repaired by qualified personnel and only with original spare parts.
Thus it is assured that the safety of the electric tool is being obtained.
2.
P A R T I C U L A R I N F O R M A T I O N - Please note
This diamond wall saw is only intended for industrial use and may only be operated by trained personel.
Proper use extends only to the sawing of rock, concrete and masonry.
For operation the relevant regulations must be observed.
Power tools must regularly (approx. 6 months) be checked on safety by a specialist.
Wear ear protection when working with this machine.
13
Werbung
Inhaltsverzeichnis
