Connecting The Speakers - Samsung HT-E450HT-E453HT-E455 Benutzerhandbuch

Installing the Speakers on the Tallboy Stand
* HT-E453 only - Front Speakers
* HT-E455 only - Front/Surround Speakers
1. Turn the Stand Base upside-down and connect it to the Stand.
2. Insert three screws (5*15, For connecting Stand & Stand Base) clockwise
into the three holes marked using a screwdriver as shown in the illustration.
!
CAUTION : When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged. (torque
screwdriver- below 15 kg.f.cm)
3. Straighten a supplied speaker wire and put in the hole on the centre of
Stand Base.
4. Connect the upper Speaker to the assembled Stand.
5. Insert another large screw (5*15, For connecting Speaker & Stand)
clockwise into the hole on the rear of the speaker using a screwdriver.
6. This is the appearance after the speaker is installed. Follow this
steps to install other speaker.

Connecting The Speakers

1. Press down the terminal tab on the back of the speaker. (HT-E453/E455
Only)
2. Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab.(HT-E453/E455 Only)
3. Connect the connecting plugs to the back of the product by matching the
colours of the speaker plugs to the speaker jacks.
In case of HT-E450
Front Speaker (R)
Surround Speaker (R)
* Refer to page 16 for the speakers of HT-E453/E455.
SPEAKERS OUT
FA NET
(Only For Service)
SURROUND SUBWOOFER SURROUND
Subwoofer
1
Stand Base
Stand
3
5
Black
Center Speaker
Front Speaker (L)
VIDEO
AUX IN 2
OUT
FM ANT HDMI OUT
OPTICAL
DIGITAL
AUDIO IN
Surround Speaker (L)
2
4
Speaker
Stand
6
Red
17
English