Connecting The Speakers - Samsung HT-D5530K Bedienungsanleitung

Installing the Speakers on the Tallboy Stand
* HT-D5530 only - Front Speakers
* HT-D5550 only - Front/Surround Speakers
1. Turn the Stand Base upside-down and connect it
to the Stand.
2. Insert small screws (4x20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
!
CAUTION

When you use a torque screwdriver, be careful not
to put excessive force. Otherwise, it runs idle or
can be damaged. (torque screwdriver- below 15
kg.f.cm)
3. Connect the upper Speaker to the assembled
Stand.
4. Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the
rear of the speaker using a screwdriver.
5. This is the appearance after the speaker is
installed. Follow this steps to install other speaker.

Connecting The Speakers

1. Press down the terminal tab on the back of the speaker.
2. Insert the black wire into the black terminal (–) and the red wire into the
red terminal (+), and then release the tab.
3. Connect the connecting plugs to the back of the product by matching the
colours of the speaker plugs to the speaker jacks.
In case of HT-D5500
Front Speaker (L)
Centre Speaker
* Refer to page 18 for the speakers of HT-D5530/HT-D5550.
HT-D5500_ELS_1226.indd 19 HT-D5500_ELS_1226.indd 19
CENTER
SUBWOOFER
SPEAKER IMPEDANCE : 3
Subwoofer
ONENT OUT NT OUT
VIDEO OUT VIDEO OUT
1
Stand
Base
Stand
3
Speaker
Stand
5
or
Surround Speaker (L)
SPEAKERS OUT
FRONT SURROUND
FRONT SURROUND
SPEAKERS OUT
CENTER FRONT SURROUND
SUBWOOFER FRONT SURROUND
SPEAKER IMPEDANCE : 3
2
4
Black
Red
Front Speaker (R)
Surround Speaker (R)
19
English
2011-12-26 2011-12-26 1:23:48 1:23:48