Information; Displaying Signal Information; Updating Software - Grundig GR 22-110 Bedlenungsanleitung

CHANNEL SETUP
Auto Tuning
Digital Manual Tuning
Analogue Manual Tuning
Programme Table
Signal Information
CA - Module Removed
Active Antenna Power On
Back
Select
Exit
OPTIONS
Language Settings
Restore Factory Defaults
OSD Timeout Off
PC/HDMI Game Mode Off
Automatic Update On
Software Update
Back
Select
Exit

INFORMATION

Displaying­signal­information
(only for digital television channels)
1 Open the menu with »MENU«.
– T he »PICTURE« menu appears.
s
2 Select the menu »CHANNEL SETUP« with »
s
s
3 Select »Signal Information« with »
s
confirm.
– Y ou will see information on the channel, modulation, quality
and signal strength.
Notes:
The lower section of the menu shows the signal properties. The
further the bar for »quality« and »Signal Strength« extends to the
right, the better the reception signal.
The signal level not only depends on your receiver system, but
also on the channel which is currently active. Remember this
when aligning your antenna using the signal level display.
4 Press »MENU« to end the display.
Updating­software
(only for digital television channels)
1 Open the menu with »MENU«.
– T he »PICTURE« menu appears.
s
s
2 Select the »OPTIONS« menu with »
3 Select the »Software Update« menu by pressing »
s
4 Press »OK« to start the software update.
– The software is updated automatically, if possible.
5 Press »MENU« to end the setting.
­ - ------------------------------------------------------------------------------
« or »
r
« or » « and press »OK« to
q w
« or » «.
r e
«.
e
« or » «.
q w
­ 5 9