Buttonhole Stitching - Blaupunkt CASUAL 845 Bedienungsanleitung

Machine Setting
Stitch selector
Stitch (1)
4
- -
1
2
Stitch length
Upper thread
tension dial 1 to 5
4
3
Buttonhole foot
2
Make a sample button hole using a piece
of the sample material as the garment.
Place the button on the fabric sample and
mark the top and bottom to determine the
buttonhole length.
4
Set the stitch selector at " ". Sew up the
3
right side of the buttonhole. Stop the machine
when yo u are directly opposite the first stitch
on the left hand side and raise the needle.

Buttonhole Stitching

4
-
3
2
1
Set the stitch selector at "
Slide both threads to the left.
Lower the needle into the
garment where the buttonhole
is to start, and lower the foot.
5
Set the stitch selector at "
bartacks stitches and raise the needle up
from the fabric.
Set the stitch length control to "0" and the
stitch selector at straight stitch sewing. Sew a
few locking stitches.
41
2
". Sew down the left side stopping
1
at the bottom mark. Raise the
needle.
6
4
". Sew 5 Remove the fabric from the machine and cut
2
the sewing threads. Insert a pin inside the
bartack. Then cut the opening with a seam
ripper. Take care not to cut the stitches.
3
4
Set the stitch selector at " ",
2
sew 5 stitches of bartack and
raise the needle up from the
fabric.
EN