Sewing Buttons - Blaupunkt CASUAL 845 Bedienungsanleitung

EN
Machine Setting Machine Setting
Sti Sti tch (9)
Upper thread Upper thread
tension dial tension dial 1 to 4
Use the darning plate for button sewing (see page 10). Use the darning plate for button sewing (see page 10).
1
A pin can be placed on top of the button to form a shank. A pin can be placed on top of the button to form a shank.
Set the stitch selector at " ". Align both holes of the button with
the slot of the foot and place the left hole the slot of the foot and place the left hole
of the button just below the needle point. Lower the foot and turn the of the button just below the needle point. Lower the foot and turn the
pattern selector until the needle point comes pattern selector until the needle point comes
just above the right hole of the button. Sew about five stitche just above the right hole of the button. Sew about five stitche s and
raise needle. Set the stitch selector at " raise needle. Set the stitch selector at "
again and sew a few stitches to lock thread. again and sew a few stitches to lock thread.

Sewing Buttons

Stitch selector
Zigzag foot
Stitch length control any number (not
necessary to adjust)
Darning plate
3
2
1
2
"
40
3
To strengthen the shank, cut the To strengthen the shank, cut the
threads leaving a 20cm (8") trail. threads leaving a 20cm (8") trail.
Bring the needle thread down
through the hole
in the button and wind it around in the button and wind it around
the shank.
Draw the thread to the wrong
side and knot.