Samsung SNC-B2315P Bedienungsanleitung Seite 63

To setup the camera
1
Click <SYSTEM>  <CAMERA>.
You can select one from <Image Flip>,
<Shutter>, <IRIS>, <BLC>, <AGC>,
<White Balance>, <Day & Night>,
<Detail>, <Y-Level> and <C-Level>.
2
To complete the setting,
click the [Apply] button.
<Image Flip>: Flips the image in vertical or horizontal direction.
<Shutter>: Electronic shutter speed can be adjusted if monitoring a fast-moving subject.
(Available Speeds: Off, 1/100, 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/10K, Auto X2,
Auto X4, Auto X6, Auto X8, Auto X12, Auto X16, Auto X24, AutoX32, AutoX48, AutoX64,
AutoX96, AutoX128, and AutoX256)
<IRIS>: Automatically control the iris depending on the amount of incoming light.
At Level 1, brightness is set; at Level 2, shutter speed is set.
WDR Level 1: 0, 1, 2, 3, 4, 5, 6, 7, 8 Level 2: 0, 1, 2, 3, 4, 5, 6, 7, 8
ALC Level 1: 0, 1, 2, 3, 4, 5, 6, 7, 8
ELC Level 1: 0, 1, 2, 3, 4, 5, 6, 7, 8
<BLC>: Allows for appropriate correction if the subject is situated under severe backlight.
(Available Settings: Off, Bottom, Top, Left, Right, and Center)
<AGC>: Automatically controls the gain when video data of less than a specific level of brightness is
acquired (poor lighting). This option is deactivated if Shutter is set to auto.
(Available Settings: Off, Low, and High)
<White Balance>: A correction feature that ensures white balance under any level of color
temperature.
ATW1: The range of the color temperature that can be changed is approx.
ATW2: The range of the color temperature that can be changed is approx.
AWC: The color temperature is adjusted appropriately to the current surroundings.
3200K: The color temperature is set to 3200K.
5600K: The color temperature is set to 5600K.
<Day & Night>: The camera can be configured to record in color during the day and in black and white
at night. (Available Settings: Color, BW, Auto, and Ext)
The IR (Infrared) filter function of the camera can be switched on or off.
<Detail>: Enables vertical and horizontal sharpness control. (Available Settings: 0, 1, 2, and 3)
<Y-Level>: Used to configure the sync signal and total brightness signal levels. (Available Settings: 0, 1,
2, 3, 4, 5, 6, 7, and 8)
<C-Level>: Used to configure the burst signal and total color signal levels. (Available Settings: 0, 1, 2,
3, 4, 5, 6, 7, and 8)
2500K – 9300K.
2000K – 10,000K.
_59
Setting Up