D) Pairing Wireless Microphone/Pocket Transmitter With Receiver Station; Audio Playback - Renkforce BM-7200 Bedlenungsanleitung

d) Pairing wireless microphone/pocket transmitter with receiver station

Set all volume controls to zero before connecting the receiver station to the mains and turning
on latter one. Non-observance of this instruction can cause damage.
• Turn on the receiver station.
Wireless microphone
• Turn on the wireless microphone
• Decide whether to transmit the wireless microphone to audio channel A (CH.A) (left side of the receiver station's
display) or audio channel B (CH.B) (right side of receiver station's display).
• Press and hold the SET button until
• Use the UP and DOWN buttons to select the desired channel.
• Press and hold the SET button until
- Pairing signals will be transmitted for approx. 8 seconds. After that,
repeated.
• Hold the IR sensor IR (17) of the wireless microphone close to the IR sensor iR (5) of the receiver station. The
channel will be transmitted to the microphone.
• Check in the display, whether microphone and receiver station show the same channel.
- If yes, pairing has been completed.
- If not, repeat the operation.
• After successful pairing,
• When turning off the microphone and receiver station, both devices will be paired automatically after turning them
on again. This requires the receiver station to be set on the same channel as the microphone.
Pocket transmitter:
• Open the battery compartment to uncover the IR sensor iR (25).
• Pair the pocket transmitter the same way as the wireless microphone.
You may pair additional microphones that are compatible.
e) Audio playback
• Turn on the connected audio device.
• Use the VOLUME.A (4) and VOLUME.B (4) volume controls on the receiver station and the volume control on the
connected audio device to adjust the volume as desired.
• A paired wireless microphone will transmit signals to the receiver station. Latter one will then transmit the signals to
the connected audio device. Observe the applicable ranges in regard to the signal strength setting:
- Setting : max. 30 m, Setting
• Turn off the wireless microphone and pocket transmitter after use, and set the POWER on/off button on the receiver
station to 0 position.
starts flashing.
lights up and
or lights up in the LCD of the receiver station.
: max. 25 m
starts flashing in the display of the receiver station.
turns off and the operation must be
35