Renkforce BM-7200 Bedlenungsanleitung Seite 33

Setting up channels:
• Press and hold the SET button until
• Use the UP (2) and DOWN (6) buttons to set the desired frequency. Every frequency is allocated to a channel.
- There are a total of 21 channels available for each audio channel.
- It is not possible to operate two devices with different frequencies (allocated channels) simultaneously using the
same audio channel (
• It is possible to allocate the same frequency to both the wireless microphone (e.g. to audio channel A) and pocket
transmitter (e.g. to audio channel B).
For example:
Wireless microphone to audio channel A: Channel 005, 863.40 MHz
Pocket transmitter to audio channel B: Channel 005, 863.40 MHz
In this scenario, however, it is not possible to operate the wireless microphone and pocket transmitter at the same time.
The channel will be allocated to the device switched on first.
Searching free channels:
• Use the frequency scan function to search free channels.
• Press and hold the SET button until
• Press the SET button repeatedly until
• Press the UP or DOWN button to search the next free channel.
• The automatic channel search stops at the next free frequency, and both the channel and the frequency will be
displayed on the LCD.
Selecting the signal strength:
• There are two signal strength settings available –
- When using microphones simultaneously, the
• Press and hold the SET button until
• Press the SET button repeatedly until
• Use the UP and DOWN button to select
When changing the signal strength setting, it must be retransmitted to the wireless microphone or pocket
transmitter using the IR sensor iR (5).
When pairing, the signal strength setting is also being transmitted to the wireless microphone or pocket
transmitter.
starts flashing.
or ).
starts flashing.
starts flashing.
starts flashing.
starts flashing.
or
(strong), (weaker)
setting can reduce interferences.
.
33