DUROFIX RG6020-180 Bedienungsanleitung Seite 9

with the spinning accessory could snag your clothing, pulling the accessory
into your body.
p. Regularly clean the power 'tool's air vents. The motor's fan will draw the
dust inside the housing and excessive accumulation of powdered metal may
cause electrical hazards.
q. Do not operate the power tool near flammable materials. Sparks could
ignite these materials.
r. Do not use accessories that require liquid coolants. Using water or other
liquid coolants may result in electrocution or shock.
s. Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and
wash exposed areas with soap and water. Allowing dust to get into your
mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
Kickback and Related Warnings:
a. Maintain a firm grip on the power tool and position your body and arm to
allow you to resist kickback forces. Always use auxiliary handie, if
provide, for maximum control over kickback or torque reaction during
start-up. The operator can control torque reactions or kickback, if proper
precautions are taken.
b. Never place your hand near the rotating accessory. Accessory may
kickback over your hand.
c. Do not position your body in the area where power tool will move if
kickback occurs. Kickback will propel the tool in direction opposite to the
wheel's movement at the point of snagging.
d. Use special care when working corners, sharp edges etc. Avoid bouncing
and snagging the accessory. Corners, sharp edges or bouncing have a
tendency to snag the rotating accessory and cause loss of control or kickback.
e. Do not attach a saw chain woodcarving blade or toothed saw blade. Such
blades create frequent kickback and loss of control.
Safety Warnings Specific for Grinding and Abrasive Cutting-Off Operations:
a. Use only wheel types that are recommended for your power tool and the
specific guard designed for the selected wheel. Wheels for which the power
tool was not designed cannot be adequately guarded and are unsafe.
b. The grinding surface of centre depressed wheels must be mounted below
the plane of the guard lip. An improperly mounted wheel that projects
through the plane of the guard lip cannot be adequately protected.
c. The guard must be securely attached to the power tool and positioned for
maximum safety, so the least amount of wheel is exposed towards the
operator. The guard helps to protect the operator from broken wheel
1English1
English -8