DUROFIX RG6020-180 Bedienungsanleitung Seite 18

Speed Setting (RG6020-180)
After turn ON the switch, press the button
this time, the position where the LED light shows the light signal is the setting speed:
1. Low speed: 4000 RPM
2. Medium speed: 6000 RPM
3. High speed: 80000 RPM
4. The red light is on to warn: the grinder is abnormal, or the protection is activated.
Setting (RG6020-230)
After turn ON the switch, Green light is ON
The red light is on to warn: the grinder is abnormal,
or the protection is activated.
Protection
The battery temp. is over / low
The grinder is overheated
General Operation
1. If you have just installed an accessory or are beginning a period of work, test the
wheel by letting it spin for one minute before applying it to the workpiece.
2. Use a clamp, vise or other practical means to hold your work, freeing both hands
to control the angle grinder.
3. To start the angle grinder, grasp the handle and side handle firmly and push the
switch lock lever (2) to the back to press the trigger switch to ON
4. Control pressure and surface contact between accessory onto work. Too much
pressure causes accessory failure or slows speed.
5. To stop the angle grinder, depress to release the trigger switch.
6. When finished, turn off the angle grinder and make sure it comes to complete
stop before laying it down.
NOTE
For Grinding, while using a depressed center disc, it should use the upper
surface of the disc to grind the workpiece. Not use the opposite surface to grind
the workpiece.
For Type 27 discs, hold the tool at the recommended angle 5∘to 15∘angle to the
work surface (IEC 60745-2-3), using constant pressure for a uniform finish. Too
1English1
with your finger to set up the speed. At
。
Warning
Red light ON
Red light flash
English -17
Troubleshooting
Replace the battery
Cool the grinder