Accessories - Durofix Rg6020-180 Bedienungsanleitung

great angle causes concentrated presure on small areas which may gouge or
burn work surface.
For cutting, while using a depressed center disc, use the machine at an angle of
90∘to cut the target surface.
NOTE
For cutting, while using a depressed center disc, use the machine at an angle of
90∘to cut the target surface.
WARNING
Remove the battery pack from this tool before cleaning solutions.
NOTE
This tool is lubricated before it leaves the factory. This lubrication should last for the
life of the tool. No further lubrication is required.
CLEANING
With the motor running, blow dirt and dust out of all air vents with dry air at least once
a week. Wear safety glasses when performing this. Exterior plastic parts may be
cleaned a damp cloth and mild detergent. Although these parts are highly are solvent
resistant, NEVER use solvent.
CHARGER CLEANING INSTRUCTIONS
Dirt and grease may be removed from the exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or any cleaning solutions.
1English1
Fig. 7
MAINTENANCE

ACCESSORIES

English -18