Create Netbot LS50 Bedienungsanleitung Seite 10

• Before starting the machine, clear scattered cables, hard objects, sharp objects (such as
nails and glass) from the floor, and remove sharp, fragile, valuable, and potentially dan-
gerous objects. This will prevent personal injury or property damage caused by machine
entanglement, jamming, dragging, or collisions.
• If the product is used in a hanging environment, please provide a guardrail to prevent the
vacuum cleaner from accidentally falling or knocking over objects when falling, causing
personal injury or property damage.
• During the initial cleaning process, it is recommended to follow the vacuum cleaner
throughout the entire process to help resolve any minor issues. After handling, the robot
will be able to clean without problems in future cleanings.
• If some areas don't need cleaning or there are areas where the robot gets stuck too much,
you can create a restricted area using the mobile app to prevent the vacuum from entering
unwanted areas.
• Do not let the robot absorb hard or sharp objects (such as decoration residue, glass, nails,
etc.), otherwise it may scratch the robot and the floor.
1. Connect the power cord and tidy up any excess cable.
2. Please do not move the charging base during operation and avoid
direct light on the charging base. Exposure to sunlight may interfere
with the charging signal and prevent the robot from returning to the
charging base.
3. Place the charging base against the wall on a flat floor and connect to the power supply.
• Make sure to leave at least 0.5 m of separation on both sides of the charging base and
1.5 m from the front.
• If the power cord hangs on the floor, it can be pulled by the robot vacuum cleaner. The
charging base could be pulled and disconnected from the power source, do not allow the
cable to drag on the floor.
• The charging indicator light will always be on when the base is connected to the light.
4. Press and hold the power button
dicator light to turn on and place the robot on the charging base. The message "Start
charging" indicates that charging has been completed successfully.
Note: The robot vacuum cleaner will not work if the battery is insufficient. Please place the
robot on the charging base and the device will start charging automatically.
E NGL I SH
10
FACILITY
To start, turn on the vacuum cleaner, wait for the in-