REDCAT RER17042 Bedienungsanleitung, Kurzanleitung Seite 19

GYRO GUIDE
GYRO
RCR-2CENR RADIO SYSTEM
FEATURES:
CNC aluminum alloy case for high
efficiency cooling and protection.
High-performance gyroscope sensor.
Compact size for easy installation.
Easily adjusted dual gain modes.
EPA features for matching different scale
car models
Compatible with latest Futaba SBUS2
protocol
Perfect for RC competition drift cars.
Function Switch:
* EPA (End Point Adjustment)
Hold the ENDPOINT button while powering on, which should cause the yellow LED to blink slowly, indicating your gyro is in the endpoint
adjustment mode. Hold the steering wheel on your transmitter such that the servo is in one of the desired maximum travel positions,
either left or right. While holding the wheel in this position, tap the ENDPOINT button. This should cause the yellow LED to blink 2 times
quickly, the red LED to become solid, and the green LED to blink slowly, indicating that the current position has been saved as an
endpoint. Next, turn the wheel to the opposite desired endpoint, and press the ENDPOINT button again to save the second endpoint.
After 2 seconds, the gyro will automatically initialize and enter normal operation.
* Restore Default Endpoints
Hold the ENDPOINT button while powering on, which should cause the yellow LED to blink slowly, indicating your gyro is in the endpoint
adjustment mode. Release the ENDPOINT button, then press it again and hold for 3 seconds, until the flashing pattern of the yellow LED
changes. Release the button, and after 2 seconds the gyro will automatically initialize and enter normal operation.
* Gyro Direction (Gain Reversing)
While the gyro is in normal operation, hold the ENDPOINT button for 4 seconds, until the yellow LED blinks 3 times, and release. This
causes the gyro to toggle between positive and negative gain settings.
* Dual Gain Mode Setting (Normal / AVCS Mode)
While the gyro is in normal operation, quickly tap the ENDPOINT button twice. The yellow LED should come on for 3 seconds, which
indicates the gyro has switched between normal and AVCS mode. In normal operation the LED is green, with AVCS the LED is Red.
Specs:
Model:
Casing:
Weight:
Dimensions:
Operating Voltage:
Current Drain:
Operating Temperature:
Input Signal:
Output Signal:
Control System:
Dual Mode Gain:
Receiver (Sensitivity Adjustment)
Receiver (Control Servo Direction)
Supports S.BUS2 input
TM
HEXFLY GX-1
Aluminum 6061
10g
25.7 x 24.7 x 9.5mm
3.7 ~ 8.4V
20mA/6V
-10 deg. C~ +50 deg. C
PWM （50-333Hz） / SANWA SHR; SSR / FUTABA S.BUS2
1520uS （50Hz/333Hz） / SANWA SSR
PID Control System
Normal / AVCS Mode
Servo
-EPA
-Reset
MOD
-Gyro Direction
-Dual Gain
18
LED
Limit Gain
(Sensitivity Adjustment)