Before Commissioning - Silva Mw-R 25.3 Bedienungsanleitung/Sicherheitshinweise

­ Packaging materials such as plastic bags or Styrofoam parts are
dangerous for children. Therefore, keep these items away from children.
­ This manual is intended to familiarize you with the safety instructions
and features of this device. Please keep this manual in a safe place for
future reference.
Intended Use:
­ The appliance is designed for defrosting, reheating, and cooking food and/or beverages.
Use for other purposes is not permitted.
­ This device is designed for indoor use only. Do not use it outdoors.
­ The device is not intended for commercial use or for use in laboratories, but exclusively for
use in the home, in coffee kitchens in offices or workshops as well as in apartment buildings,
bed and breakfast establishments, motels or bed and breakfast establishments.
­ Use the device only for the functions described in this manual. Any other use is considered
improper and may result in damage to the device or injury.
­ Failure to observe the points listed in this manual will void any warranty claim.
Unpack and check the device:
- Remove all packaging material and inserts from the device. The packaging material is
recyclable.
- Check the appliance and the power cord for damage after unpacking and before each use.
The door, including the viewing window and door locks, must not be bent or damaged to
prevent microwave radiation from escaping. This also applies to the entire housing and the
cooking chamber walls.
If damaged, do not operate the appliance. Take it to a specialist workshop for repair.
- not remove the protective film on the inside of the door.
Setting up the device:
- Only place the microwave on a sufficiently stable, level and heat-resistant surface and
protect it from high temperatures and moisture.
- Do not place the device near easily flammable objects (e.g. curtains).
- The appliance must not be placed directly above a hob or other heat-generating appliance.
This could damage the microwave.
The spacer on the back of the device must not be removed.
-
- The device's feet must not be removed.
- Adequate air circulation must be ensured. Therefore, no objects should be placed on top of
the device, and the following distances from walls must be maintained:

Before commissioning

18