Charging Indicator - Vevor Em2425 Anleitungsblatt

4. Transmit Signal Strength Indicator/Impedance Indicator
In digital/analog wire tracking mode, it indicates the current
transmit signal strength; the more lit LEDs, the stronger the signal.
In continuity test mode, it indicates the impedance of the tested
conductor; the more lit LEDs, the less the impedance.
5. Signal Strength up Button
In digital/analog wire tracking mode, press this button once to
increase the transmit signal strength by one level. The number of
lit transmit signal strength LEDs will increase by one.
6. Function Toggle Switch
The left gear is digital wire tracking mode, the middle gear is analog
wire tracking mode, and the right gear is continuity test mode. The
indicator of selected mode will light up as an indication.
7. Power Button/Signal Strength down Button
Press and hold this button for about 2 seconds to turn on or off
the transmitter.
In digital/analog wire tracking mode, press this button once to
decrease the transmit signal strength by one level. The number
of lit transmit signal strength LEDs will decrease by one.
8. Analog Wire Tracking Indicator
When this red indicator lights up, it indicates that the transmitter is
in analog wire tracking mode.

9. Charging Indicator

This indicator is a dual-color LED. Red continuously on indicates
charging and green always on indicates full.
- 5 -