VEVOR R5 Benutzerhandbuch Seite 14

3. Place the cleaner on a flat work surface. Open the buckle on the front of the
cleaner by pulling it out. Lift the front of the top cover up and then firmly pull it
forward.This will separate the top cover from the cleaner body and you will now be
able to lift the top cover straight up from the cleaner body (See Figure 12). Set the
cover aside.
Note: The top cover is designed to fit tightly so you may have to wiggle it a little.
4. Pull the turbine cover straight up and off of the cleaner body. Set the turbine
cover aside. See Figure 13.
5. Remove any visible obstructions from the turbine and turbine cover.
6. Replace the turbine cover with the swivel assembly oriented towards the front
of the cleaner, See Figure 13.
7. Visually inspect the rest of the cleaner and remove any debris that may be in
the gears, drive shafts, swivel assembly, etc.
8. Repeat step 2 (turning the right wheel) to insure that the cleaner runs smoothly.
9. Place the top cover over the swivel assembly.
10. Place the tabs on the back side of the top cover into the slots on the back side
of the cleaner body (See Figure 14). Once these tabs are seated in the slots the
front of the cover will fall into place.
11. Lock the top cover onto the cleaner body with the locking buckle on the front of
the cleaner.
13