VEVOR R5 Benutzerhandbuch Seite 11

CLEANER ADJUSTMENTS AND OPERATION
Hose Length
Note: The pump must be on when you check the hose length. The hose contracts
when the pump is operating and will be longer when the pump is off.
While the cleaner is operating：
1.Position cleaner at the furthest point of the pool from where it's attached. Use a
pool pole and brush to easily position the cleaner in the pool.
2.The hose should be long enough to reach the end of the pool, plus one hose
section before the standard Female-Female Hose, See Figure 10.
3.Remove any excess hose lengths from the middle of the hose assembly.This will
ensure you do not alter the position of the hose float.
4.Save extra hose sections for use as needed for replacement.
Note: Turn pool pump off when adding or removing hose sections.
Return Line Water Flow
IMPORTANT: The water flow from your return line can push the Pool Cleaner's
hose and affect its performance. It may cause the cleaner to steer away from the
end of the pool where the return line is located, or it may cause your cleaner to
remain in one section of the pool. To correct this, use the eyeball (not included).
10