Electrical Connection - Gre Versapool Mg320 Bedienungsanleitung

REQUIREMENTS FOR CORRECT INSTALLATION
This filter is easy to install and can be assembled by one adult in about 1 hour, taking care to follow
the instructions detailed in this manual correctly. It only needs one slotted screwdriver to tighten the
hose clamps.
2. BEFORE CONNECTING THE FILTER
LOCATION
Place the filter on a flat, solid surface at a minimum distance of 3.5 meters from the pool (in accordance
with standard installation regulations of electric equipment in swimming pools in force in each region
or country) and at the same level as the bottom of the pool to prevent air from entering the cleansing
circuit and to ensure that the filter remains primed (Fig. 2). The filter should be protected from sun
and rain, and kept in a sufficiently ventilated area during operation. Never cover it during operation.
In models where pool connection hoses are supplied, these will be 4 .5 metres in length. In all cases,
check that this length is sufficient in order to install the apparatus on a flat, solid surface more than
3.5 metres away from the pool. If the hose length is insufficient, contact your service centre.
When hoses are not supplied with the apparatus, hoses with a minimum length of 4.5 metres should
be used which allow the filtering equipment to be placed on a flat, solid surface more than 3.5 metres
away from the pool. This hose set is available as an optional kit from your vendor.
It is important to check that the suction ports are not blocked.
During the installation process, if in doubt, contact the vendor of the equipment.
ASSEMBLY
Once the filter is set in place, proceed as follows:
·
Connect the end of the suction hose to the skimmer tightening firmly with a clamp. Repeat the
same procedure with the return nozzle terminal and connect the discharge hose.
·
Following installation, the first cycle of filter backwash should be performed. In order to do so,
follow the instructions in section 5.3.

3. ELECTRICAL CONNECTION

All electrical installations should comply with the following standard:
European Low Voltage Directive 2014/35/UE, EN 60335-2-41, safety of household or
similar electrical appliances, particular requirements for pumps.
Instruction Manual - VERSAPOOL FILTER 9