G) Nfc Mode - Renkforce RF-TB500WW Bedienungsanleitung

Music playback from your Bluetooth device
• The soundbar supports the following profiles in Bluetooth mode:
A2DP (Advanced Audio Distribution Profile)
AVRCP (Audio/Video Remote Control Profile)
• If your mobile device supports AVRCP, you can use the remote control to jump to the next or previous track as well
as start or pause playback.
You can start or pause playback with the PAIR (4) button on the soundbar.
Disconnect the Bluetooth connection one of the following ways:
• Switch the soundbar to a different audio source (e.g. AUX).
• Deactivate Bluetooth on your mobile device. The soundbar emits the audible message "Disconnected" (connection
lost) in confirmation.
• Press the BT PAIR (22) button on the remote control or press and hold the PAIR (4) button on the soundbar. The
soundbar emits the audible message "Pairing".

g) NFC mode

NFC stands for "Near Field Communication". Please note NFC will only work with this soundbar if your mobile device
is equipped with NFC.
• Turn the soundbar on.
• Press the SOURCE (2, 19) button repeatedly to
select Bluetooth as the audio source.
• Enable NFC on your mobile device.
• Place your mobile device on the NFC sensor
area (6). Your mobile device vibrates or a
message appears on the display. Your mobile
device turns on automatically in Bluetooth mode.
• Start audio playback on your mobile device.
• Place your mobile device again briefly on the NFC sensor area to disconnect the link or to disable NFC on your
mobile device.
For data transfer via NFC, you may need to remove the protective cover of your mobile device to establish
a strong enough connection.
42
Audio playback
Music control via the remote control of the soundbar
and audio playback