B) Turn On And Standby Mode; Selecting An Audio Source; D) Setting The Volume And Mute - Renkforce RF-TB500WW Bedienungsanleitung

b) Turn on and standby mode

• After connecting to the mains grid, the soundbar switches to standby mode. The standby indicator (8) is lit red.
• Press the on/off button (1, 26) to switch on the device. The LED of the previously selected mode is lit or flashes.
• Press the on/off button again to switch the device back to standby mode.
• If the device detects no signal input for approx. 15 minutes, it automatically switches to standby mode. The standby
indicator lights up red.
• Disconnect the mains cable from the mains outlet to completely disconnect the device from the grid.
c) Selecting an audio source
• Press the SOURCE button (2, 19) repeatedly to select the desired audio source.
• The active mode is displayed by the status LEDs (8):
Mode LED
Standby Solid red
AUX Solid green
Coaxial Flashing green
Bluetooth Solid blue
Optical Solid white
HDMI Flashing white
If there is no sound in the modes coaxial/optical/HDMI and the status LED flashes quickly, you may need
to enable the PCM output signal on your audio source.
In AUX mode, the soundbar and subwoofer switch on automatically as soon as the connected audio source
is turned on.

d) Setting the volume and mute

• Press the VOL+ / VOL– (5, 25) buttons to adjust the volume:
VOL+ increases the volume
VOL– decreases the volume
• If you want to mute the sound, press the MUTE button (24). Press the MUTE button again or press VOL+ to turn
the sound back on.
• The status LED flashes quickly while the volume is being set.
• When you have reached the maximum volume and press VOL+, the LED indicator flashes once.
• When you have reached the minimum volume and press VOL–, the LED indicator flashes once.
40