Beko RHO 8323 BT Benutzerhandbuch Seite 13

4 Operation
Function description
• <Work/Standby>:
the power key "
1
key " " to enter the standby state. <Shut down>: Under the working state, press
the power key "
power cord, wait for the whole machine to cool, and place the heater stably.
• <Mode selection>:
2
such as high gear, medium gear and low gear.
• <Scheduled work>:
uled work setting screen. Press "
press "
scheduled time will reach the working status of the machine.
• <Scheduling standby>:
enter the scheduling standby setting screen. Press "
the scheduling time, press "
scheduling time, and the scheduling time is in the standby state to the machine.
1. The scope of scheduling is for 0~24hours, and press "
time to increase or decrease 1 hour. When the set value is 0H, press the "
to set the time for 24H. When the set value is 24H, press the "
3
setting time is 0H. When the set value is 0H the scheduling is canceled. When
the set value is not 0H the scheduling is started. Set the appointment time,
press the timing key "
exit scheduling mode.
2. If the scheduling time isset, press the power button "
state and cancel the scheduling.
3. After the scheduling is started, press the scheduling key "
maining time of the appointment and reset the scheduling time. During the
scheduled time, the machine is shut down or started upunder temperature
control, and the scheduled time is always normal and free from down time.
During the scheduled time, it is cleared incase of power failure.
4
<Temperature Setting>:
or " " key to set the temperature, press and hold the "
quickly set the temperature; after setting the temperature,have non-operation
for 5 seconds,exit the temperature setting screen.
hold the "
Oil Filled Heater / User Manual
Plug in the power,the buzzer will "beep" for along time, press
" to enter the heating working state, and then press the power
" on the control panel to enter the standby state, unplug the
For work status, press "
Tap the timer key "
" key or " " key for along time to quickly set the scheduled time, and the
Under the working status, press the timer key "
" key or "
Under the working status,press and hold the "
" key or the " " key to quickly set the scheduling time.
" key to select one of work modes
" in standby mode to enter the sched-
" key or " " key to set the scheduled time,
" key or " " key for along time to quickly set the
" key, or without operation for 5 seconds,
<Timer Setting>:
" to
" key or " " key to set
" key or " " key each
" key
" key, and the
" to enter the standby
" to check the re-
" key
" key or the " " key to
Press and
13 / EN