Werbung
30
FUSE
FUSE Getting Started
FUSE can be used with either
analog or digital audio:
• Digital – Connect FUSE to your computer
or Playstation* console by using included
USB cable to stream digital audio.
*Some game consoles do not support USB
audio devices
• Analog – Connect the CONSOLE (2)
jack on FUSE to the headset jack on your
console controller or mobile phone using
the provided 1/8" TRRS AUX cable.
If your headset has a single 1/8"
TRRS connector, connect it to the
HEADPHONE/HEADSET (13) jack.
If your headset has separate 1/8" TRS mic
and headphones connectors, connect the
headphones connector to the HEADPHONE/
HEADSET (13) jack, and connect the mic
connector to the AUXILIARY MIC (14) input.
No need for headset adapters!
Press the POWER button to turn
on the unit.
Make sure HEADPHONE LEVEL is
set to minimum and MIC/GAME
BALANCE is set to neutral state
(no segments lit on LEFT SLIDER DISPLAY and
center segment lit on RIGHT SLIDER DISPLAY).
Set computer/console/phone
volume to 100% and play audio
(video, audio file, etc.), slide your
finger up or down on the PHONES LEVEL slider
to increase or decrease the volume until you
find the desired headphone output.
NOTE: Multiple swipes are required to move
from min to max volume.
Press and hold the MUTE button
to enter mic edit mode where the
SLIDER DISPLAYS will show your
mic level meter (left) and your selected tone
preset (right).
• MIC GAIN
While speaking into your mic, slide your
finger up/down the PHONES LEVEL slider
to increase/decrease the mic gain until
the level meter is occasionally peaking in
the amber warning segment (2nd LED
from the top). It should never be in the red
clipping segment (top LED).
31
Quick Start Guide
• TONE
While speaking into your mic, slide your
finger up/down the MIC/GAME BALANCE
slider to change the Tone Presets between
9 customized voicing settings. Listen to
each preset and pick the one that makes
your headset sound the best.
Tone Presets
Very Bright
Very Bright, Low Gate
Bright
Bright, Low Gate
Flat
Dark, Low Gate
Dark
Very Dark, Low Gate
Very Dark
To exit mic edit mode press the MUTE button
or wait until the MUTE buttons stops flashing.
PRO TIP: To pick the best preset for your
voice, record your mic audio for each
preset while repeating the same phrase.
Once complete, listen back to your recordings
and pick the best one!
Werbung
