Primo PR409IB Gebrauchsanleitung Seite 50

PR409IB
PROBLEMS
All indicator lights flash simultaneously.
The appliance stops working.
Indicator lamp "water reservoir empty"
lights up.
There are no indicator lights on.
The ice is too big and there are bits of
broken ice sticking to it.
The appliance goes through the cycle,
but no ice comes out.
SOLUTIONS
• The ice scoop is blocked. Clear the
blockage.
• The motor is broken. Contact the
after-sales department.
• The ice scoop is not in the correct
position. Remove the ice from the
scoop and press the power button.
If the appliance does not work after
restarting, please contact the after-
sales department.
• Is the water reservoir empty. Fill the
water reservoir with water.
• There's air in the pump. Restart the
appliance with the on/off button.
• The water supply is blocked. Clean
the filter on the bottom of the water
tank.
• There is no power applied to the
appliance. Check the plug is placed
in the socket.
• Check that no fuse has tripped in
your fuse box.
• It is possible that ice from a previous
cycle has ended up in the water tray.
Turn off the appliance and remove
the ice from the water tray.
• The water in the reservoir is too cold.
The recommended temperature is
between 8 and 25°C.
• The ambient temperature or the
water temperature is too high.
Do not use the appliance at a
temperature higher than 32°C and
fill the tank with cold water.
• The compressor or the ventilation
motor is broken. Contact the after-
sales service.
• There is insufficient coolant in the
appliance. Contact the after-sales
service.
50