RINSE THE LINES
It is recommended that the appliance lines be rinsed once a week or if the appliance
has been idle for a long time.
1.
Make sure the drainage hole on the bottom of the appliance is closed; then fill
the water tank with clean water.
2.
Plug the power cord into a socket. The 'in operation' indicator light flashes and
the appliance prepares to start. The appliance is now in standby mode.
3.
Press and hold the power button for several seconds until all indicator lights
flash in turn.
4.
The cleaning cycle starts. The lines will be rinsed for a few minutes.
5.
When the cleaning cycle is finished, the appliance will stop automatically.
DESCALING
Descale the appliance regularly to avoid calcification and to maintain a well
operating appliance. Use a descaling product for for example coffee makers, or use a
solution of 1/2 vinegar and 1/2 water.
1.
Fill the water tank with the descaling solution; do not exceed the maximum
level.
2.
Plug in and wait until the appliance is in standby mode; the 'in operation' indica-
tor light will flash slowly.
3.
Switch on the cleaning cycle by pressing and holding the power button for a
few seconds. All indicator lights flash alternately.
4.
The cleaning cycle starts. The pipes will be rinsed for several minutes.
5.
When cleaning cycle is finished, the appliance will automatically stop and switch
back to standby mode.
6.
Unplug and drain the descaling solution in the water tank over a sink. Rinse with
clean water and clean the reservoir.
7.
After this, refill the appliance with clean water and repeat the cleaning cycle
again to rinse the residue of the descaling solution from the pipes.
8.
Empty the water tank once more over a sink. The appliance is ready to use again.
PROBLEMS
"Ice basket full" indicator lamp is on.
PROBLEMS AND SOLUTIONS
49
WWW.PRIMO-ELEKTRO.BE
SOLUTIONS
• The ice basket is full. Empty it.
• The sensors are dirty. Clean both
sensors.
• The sensors are broken. Contact the
after-sales department.