Cleaning And Maintenance - Primo Pr409Ib Gebrauchsanleitung

PR409IB
I
During the first 3 cycles, the ice cubes may be smaller and more irregular in size.
I
When the ice basket is full, immediately remove the ice from the ice basket.
• If the 'water reservoir empty' indicator lamp lights up, there is not enough water
left in the water reservoir. Fill the water reservoir with water and press the on/off
button to restart the machine.
• If the 'ice basket full' indicator light flashes, the machine will stop working. Empty
the ice basket. If there is no more ice near the sensor, the appliance will restart
automatically.
I
Do not immerse unit, cord, or plug in water or other liquid.
I
Never use aggressive or abrasive cleaning agents.
• Switch off the appliance and unplug before cleaning.
Also remove all ice cubes.
• Drain all water from the water tank through the drain
hole at the bottom of the ice cube maker. Open the
drainage hole on the underside of the appliance above
a collecting container or a sink. To do this, you can slide
the appliance forward, so the front protrudes 55-60 mm over the front of the
worktop.
• Regularly clean the ice basket, the water tank, the water tray, the freeze fingers
and the ice shovel. Use a soft cloth with warm water and maybe cleaning vinegar
to clean the inside of the appliance. Rinse thoroughly before using the appliance
again.
• There is a water supply filter at the bottom of the water tank. Remove it for
cleaning. Clean with warm water and a mild detergent. Afterwards, replace
correctly before using the appliance again.
• Clean the outside with a damp cloth and mild detergent if necessary.
• Do not use any chemical products or products containing acids, gasoline or oil.
Do not use boiling water.
• Replace the water in the water tank at least once a day to guarantee clean ice
cubes. When not using the appliance, always drain the water from the water tank.
Always use clean water when using the ice cube maker.

CLEANING AND MAINTENANCE

48