• Remove all packaging materials and any promotional stickers.
• Place the ice cube maker on a flat and stable surface and make sure that the
ventilation openings are not blocked.
• Before using the ice cube maker for the first time: wait 2 hours after putting
the appliance in place and leave the lid open for at least 2 hours. This way the
refrigerant can settle.
• Attach the handle to the ice cube maker.
• Clean the appliance before using it for the first time. See: "cleaning and
maintenance".
1.
Place the ice cube maker on a flat and stable surface and make sure that the
ventilation openings are not blocked. Make sure the drainage hole on the bot-
tom of the unit is closed.
2.
Open the lid and take out the ice basket so you can pour water into the water
tank. It is recommended to use spring water or mineral water. Do not use hot
water, the recommended water temperature is between 8 and 25°C.
I
Caution: Make sure that the water level is lower than the maximum indication.
If the water tank is filled above the MAX indication, drain the excess water
through the drain hole at the bottom of the ice cube maker. Open the
drainage hole on the underside of the appliance above a collecting container
or a sink.
3.
Place the basket back into the appliance and close the transparent lid.
4.
Insert the mains plug into the power socket. The 'in operation' indicator light
flashes and the appliance prepares to start.
5.
Press the on/off button on the appliance to turn it on. The "in operation" indica-
tor lamp will illuminate steadily. It starts making the ice cubes and the first ice
cubes will fall into the ice basket after ± 9 minutes.
6.
To stop the appliance, press the on/off button. The appliance ends the current
cycle. Unplug the power cord after use.
7.
Clean the appliance after each use. Empty the water reservoir before storing the
appliance. Open the drainage hole on the underside of the appliance above a
collecting container or a sink.
BEFORE THE FIRST USE
USE
47
WWW.PRIMO-ELEKTRO.BE