Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.
General instructions
We do not recommend the pump working with water that is over 35 degrees for a long period of
time. The purpose of these instructions is to ensure correct installation and optimal performance of
the pump. The pump is designed for use with clean water up to a maximum temperature of 35°C.
All the materials used are of high quality and production processes are subject to stringent controls.
To prevent overloading the motor and damage due to incorrect installation, please comply with the-
se guidelines and install the pump in accordance with the technical specifications. We accept no
liability for the consequences if the pump is installed and used incorrectly.
If the pump is not permanently fitted, it must not be used when there are bathers in the pool. The
pump must be earthed and attached to an earthed power supply protected by a residual-current
device (RCD) or residual-current circuit breaker (RCCB) with a nominal residual operating current
of less than 30 mA.
4.
Fitting
Hose connectors must be sealed using Teflon tape. If connectors are not correctly sealed, air will
be sucked in. Air inside the pump impairs or prevents pressure accumulation inside the pump.
Keep hose lengths as short as possible. Excessive hose lengths reduce pump capacity. Always en-
sure that there is an adequate supply of water. The water discharge connection on the suction side
must always be immersed in water.
All hose connections must be sealed with Teflon tape to prevent leaks. We recommend at least 15
rounds of tape.
All hose parts must be able to withstand internal pressure. All hose parts must be fitted responsibly.
5.
Main power connection
DANGER Risk of electric shock!
• The pump must be a least 3.5 metres from the pool edge.
• The pump must be earthed and attached to an earthed power supply protected by a residual-
current device (RCD) or residual-current circuit breaker (RCCB) with a nominal residual
operating current of less than 30 mA.
• When used outdoors, the pump must be placed on a firm, level and well-drained surface.
The electrical connections must be protected from splashes: connections must never come
into contact with the water.
6.
Before you start
TAKE CARE!
After installation, loss of water or suction of air into the pump, the pump's filter must be filled with
water. A dry run will damage the pump!
MV-PP032-PP052-PP077-05-2025 . Swim & Fun ApS . info@swim-fun.com . www.swim-fun.com
© All rights reserved Swim & Fun ApS
Side 3
Werbung
