Cleaning And Maintenance - Royal Catering Rcmz-800 Bedienungsanleitung

6. Connect the device to the power source.
7. Set the Stopwatch for the appropriate amount of time.
a) On the stopwatch timeline, select the desired value and turn the knob in the appropriate
direction.
8. The device starts and stops working after the selected amount of time has gone off.
9. After finishing work with the grinder, disconnect it from the power source.
10. Open the cover and pour out the content of the container.
3.4.

Cleaning and maintenance

a) Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.

Wait for the rotating elements to stop.
b) Use only non-corrosive cleaners to clean the surface.
c) Use only mild, food-safe detergents to wash the device.
d) After cleaning the device, all parts should be dried completely before using it again.
e) Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
f) Do not spray the device with a water jet or submerge it in water.
g) Do not allow water to get inside the device through vents in the housing of the device.
h) The device must be regularly inspected to check its technical efficiency and spot any damage.
i) Use a soft, damp cloth for cleaning.
j) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
k) Change the blades and carbon brushes regularly.
REPLACEMENT OF THE CARBON BRUSH
To replace the carbon brush, it is necessary to unscrew the screw of the carbon brush cover, carefully
remove the used carbon brush, replace it with a new carbon brush, and place and tighten the cover of the
carbon brush.
EN