Customizing Brightness Levels; Default Setting - Lupine Wilma 7 Bedienungsanleitung

4
Customizing the brightness levels
You have the option to setup to 4 brightness
1.
Press and hold the button (for approx. 4 seconds) until one
release the button

2.
The range of brightness levels you can select will
3.
Press the button at the brightness level you want.
the first power-on click is presented

4.
Upon releasing the button, the sequence
of brightness levels automatically
restarts, allowing you to set a second
level in the same manner as the first click
set-up. This process can be repeated up
to four times, but will stop when you quit
making further selections, thus allowing
your light to operate in 1-step, 2-step,
3-step,-or 4-step modes.
38 Wilma
levels, in any sequence
green LED lights up.
begin automatically to cycle, as shown below.
0.3 W
brightness level
1.5 W
brightness level
3 W
brightness level
5 W
brightness level
7 W
brightness level
10 W
brightness level
14 W
brightness level
19 W
brightness level
23 W
brightness level
28 W
brightness level
SOS
RVLR
alpine emergency

Default setting

Default setting
1. brightness level 14 W
28 W
2. brightness level
3. brightness level 1.5 W
RVLR:
This mode includes an additional slow flash mode.
Recover factory settings:
1.
Press and hold the button for 8 seconds, until 5
release the button

2.
Disconnect the battery, and all factory settings will be restored.
4
red LEDs turn on.
Wilma 39