Troubleshooting; Miscellaneous - Lupine Wilma 7 Bedienungsanleitung

10

Troubleshooting

Problem Cause
The light does not come on
and the power LEDs do not
flash when the battery is
plugged into the lamp.
With the battery plugged in,
the power LEDs do not come
on, but the PCS LEDs flash.
The Power LEDs do not stay on
for as long as they should.
Battery cannot be charged:
Charger does not respond when
a battery is connected to
it and does not begin charging.
4 8 Wilma
Solution
Extremely discharged battery.  Charge the battery. Before
doing so be SURE to read
the "Battery cannot be
charged" section below.
Battery not plugged into the Check all plug contacts.

light or not plugged in
properly.
Faulty LED unit. Replace the LED unit.

Discharged battery.  Charge battery.
Old battery. Replace battery.

Very low ambient Keep battery warm.

temperature.
Faulty charger. Replace charger.

Unsuitable battery.  Use original Lupine battery.
The battery's internal  Leave the battery connected
electronics blocked further to the charger and wait.
discharge by shutting down. This process can take up to
It will take the connected an hour.
Charger a few minutes
to initialize and begin
charging.
Regulations:
The laws governing the allowable application domain for this lighting system may vary from
one country to another. We recommend that you inform yourself about the relevant laws in
this domain in your country.
The O-ring mounting technique, as well as the design of Wilma lamps and the Power
Control System (PCS) are protected by European and US patents.
Changes:
Rights for improvements and modifications of our products reserved.
Warranty:
The product's two year warranty applies to all components, as well as any manufacturing defect.
The warranty does not include the battery, however. In addition, any modification or improper
use of the product will void the warranty.

Miscellaneous

Wilma 49