Customizing Brightness Levels - Lupine Betty R Bedienungsanleitung

4
Customizing the brightness levels
You have the option to setup to
1.
Press and hold the button until one
release the button

2.
The range of brightness levels you can select will
3.
Press the button at the brightness level you want.
the fi rst power-on click

4.
Upon releasing the button,
of brightness levels automatically
restarts, allowing you to set a
level in the same manner as the fi rst click
set-up. This process can be repeated up
to four times, but will stop when you quit
making further selections, thus allowing
your light to operate in
3-step,-or 4-step modes.
* If in use, shown by green LED
** Will not be signalised by status LED
With red LED 0.8W
40 Betty R
4 brightness levels, in any sequence
green LED
is presented
the sequence
second
1-step, 2-step,
lights up.
begin automatically to cycle, as shown below.
1 W
brightness level
2 W
brightness level
4 W
brightness level
8 W
brightness level
12 W
brightness level
16 W
brightness level
22 W
brightness level
28 W
brightness level
34 W
brightness level
45 W
brightness level
SOS*
RVLR*
Alpine SOS*
Flash*
0.3W Center-LED **
Default setting