Linea Tielle GLASS CLEANER PRO Bedienungsanleitung Seite 59

3. Operating
" N " Cleaning Mode is Best for
tall windows. Glass Cleaner
Pro cleans in an " N " path.
CAUTION: If the remote control not able to command the Glass Cleaner Pro unit. Please check
below steps matchcode for Glass Cleaner Pro and the remote control.
Follow above preparation steps and stick the Glass Cleaner Pro onto window glass.
1. Press the Glass Cleaner Pro left rear bumper without release, at the same time press
the START/PAUSE button on robot handle. The START/PAUSE button will begin twinkles
between blue and red light. Then release your two hands.
2. Press the " Z " and "Repeat Clean" button on the remote control at the same time.
3. The START/PAUSE button will turns to solid red light. At the same time the speaker will buzz.
It means the remote control successfully matchcode with robot cleaner.
3.8 Pause
Pause Glass Cleaner Pro during cleaning by
pressing the START/PAUSE button on the
robot or on the Remote Control.
" Z " Cleaning Mode is best
for wide windows. Glass
Cleaner Pro cleans in a
" Z " path.
Direct Glass Cleaner Pro to move forward, backward,
left and right using the Direction Control stick on the
Remote Control when Paused.
Glass Cleaner Pro cleans when the Direction Control
stick are used. Switch to a different Cleaning Mode
using the Cleaning Mode Button on the Remote
Control when Paused.
8