Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Operating
Please sure there is a 13cm (5.1") clearance between the glass and obstacles in the room like
curtains or furniture.
Glass Cleaner Pro can clean horizontally mounted glass but only when using the Direction
Control Buttons on the Remote Control.
Glass Cleaner Pro can clean glass mounted at an angle but may not operate normally; in such
a case, a person should be in the vicinity to assist should there be a problem.
Do not use Glass Cleaner Pro upside down.
Glass Cleaner Pro should only be used with Glass Cleaner Pro Cleaning Solution. Using other
cleaners significantly reduces Glass Cleaner Pro 's performance and can damage the robot.
Please refer to the manufacturer's care and cleaning instructions before using Glass Cleaner
Pro on glass with an unevensurface, such as frosted, textured, patterned, or coated glass.
Product Manufacturer cannot be responsible for damage due to improper use on these surfaces.
3.2 Attach the Cleaning Pad
Turn Glass Cleaner Pro over and attach the Cleaning Pad to
the bottom of Glass Cleaner Pro smoothly. The whiteside of the
Cleaning Pad attaches to the Velcro,and the gray microfiber
side faces out. Make surethe Cleaning Pad does not cover
the Edge Detection Sensors, front bumper sensor and rear
bumper sensors.
3.3 Assemble the Power Adapter
3.4 Install the Safety Tether
A
A: Power Cord
B: Power Adapter Power Cord
B
C: Safety Pod
5
C
D: Safety Tether
D
Werbung
