Netsecur OPEN'R Benutzerhandbuch Seite 21

Fitting with adhesive fixing
- Place the adhesive on the mounting
base and press firmly with your
fingers for 10 seconds
- Remove the adhesive protection and
stick the mounting base to the wall
- Press firmly with your fingers for 10
seconds and wait 30 seconds
- Place the sensor on the mounting
base and turn it a quarter turn to the
right to secure it.
You should hear a «click», indicating
that the sensor is attached to its
mounting base.
Check that the sensor is securely fixed
to the wall.
Free standing
Use the removable bracket supplied
with the sensor.
Follow the procedure below:
- Place the removable bracket on
the back of the sensor, then turn it a
quarter turn to the right to secure it
- Place the sensor on a piece of
furniture or shelf, ideally within one
metre from the floor, to avoid damage
if the sensor is accidentally dropped
You should hear a «click», indicating
that the sensor is correctly attached
to the removable bracket.
7