Commissioning; Installation - Netsecur Open'r Benutzerhandbuch

2. COMMISSIONING

Switch on
To start, insert the supplied battery.
Compatible
CR17335/CR17345
Recommended:
The green LED on the front of the
sensor lights up and stays on for 5
seconds, then flashes once and goes
off, the sensor is switched on.
Connecting to the wireless network
Follow the installation steps indicated
on the home automation control
application on your smartphone.
- QR code with installation code on the
back of the product
- Pair manually by briefly pressing the
button on the back of the sensor. The
app will indicate a successful pairing
after the LED has gone out.
The LED on the back of the sensor will
flash every second during the pairing
process. The green LED will stay on for
15 seconds if the process is successful.
The LED will be red and steady for 15
seconds if the process has failed.
batteries: CR123A/
VARTA CR123A

3. INSTALLATION

Recommended locations
The sensor is intended for indoor
domestic use only. Ideally, the sensor
should be placed in a central location
in the room, between 50cm and
2m high. Try to place it away from
draughty areas (doors, windows, etc.)
and away from areas near heat sources
(radiators, direct sunlight, etc.).
Places to avoid
- less than 30 centimetres from the
ceiling, and more than 2 metres from
the floor
- in the open air
- in a place where the temperature is
below 0°C or above 50°C
- in a place where there is a risk of
condensation
- in a dusty or dirty place (garage,
workshop, etc.)
5