WEPTECH SWAN2-C-V Kurzanleitung

wM-Bus NB IoT Gateway SWAN2-C-V
QUICK 4-STEP GUIDE
ENGLISH
DEVICE INSTALLATION
Open the two screw covers
and mount the device to the wall. Then close the screw covers.
You can find detailed information in the
SWAN2-C-V instruction manual by using the
QR-Code or the following Link for mounting,
commissioning and configuration.
https://www.weptech.de/en/docs/swan2-c-v.html
APP INSTALLATION
Install the WEPTECH NFC Configurator App from Playstore on
your Android smartphone by using the QR-Code shown on the
left and run it.
CONNECTION
Hold your smartphone over the NFC interface
last four digits of the IMEI as the password. The IMEI number
can be found on the type plate.
GET STARTED
After the NFC link has been established, the following actions
can be performed:
•
Check the cellular connection.
•
Perform a test upload.
•
Check the radio connection to your wM-Bus devices.
1 on the front side of the housing
3 . Enter the