Xblitz DUAL VIEW Bedienungsanleitung Seite 17

9. IR LEDs
Thanks to the infrared LEDs mounted on the internal lens, the camera records a clear
ima ein the dark.
. \oun 10 d ng recordi
The camera, along with video recording, can also record sound.
06. STARTING THE DEVICE
I. Placethe micro SD memory card in the appropriate port of the camera. Make sure the
card is formatted to the FAT32 or exFAT file system.
NOTE:the memory card must be inserted into the devicewhen it is turned off. The same
oes for taking out cards.
Install the camera on the holder and connect it to the power supply (accordingto the
instructions in the CAMERAINSTALLATION chapter).
3. Set in the menu:
a. Date and time.
b. Loop recordin (recordin time).
c.Se t tothe hi kest a vaila l eresolution.
d.Se t G- SENS8 R tothe lowest possibl
e.Enab le
4.Calibrat e theADAS system (see chapter 7).
S. Make sure the motion detection function is turned off. If this option remains turned on
while driving, the movements can effect on recordings. This mode should only be turned
on when you leave your vehicle parked.
6. The red LED indicates that the device is turned on even when the display device will go
into sleep mode.
7. Theflashing blue LEDmeans that the deviceis recording. When the LEDis on a fixed
camera does not record.
8. The devicerecords video material using two lenses at the same time - the front lens
records the image from the road in front of the vehicle and the rear (internal) lens captures
the image inside the car.
07. CALIBRATION
Important: Calibration should be performed while driving on a straight road. For security
reasons, ask the passenger to do so.
To properly calibrate the system, place the camera first in the desired location on the glass.
Then perform the next steps calibratin the device using the LEFTand buttons RIGHT,
accepting the individualstages,andgongto the nextoneswith the 0K. button.
I. Align a vertical red line in the center of the road lane.
2. Align the top horizontal red line with the road disappearing horizon in front of the car.
3. Align the left red line with the left edge of the lane.
4. Position the bottom
S.Align the right red line with the right edge of the lane.
6. Position the bottom horizontal red line where the mask ends to the right car.
e value so that t he camera
are d riving on uneven
OF THE LOWS
horizontal red line where the mask ends on the left sidecar.
17
does not p rotect your
roads.
SYSTEM