AEG Electrolux A72010GNX0 Benutzerinformation Seite 39

h1
h3
h5
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the gasket.
In case you do not want to carry out the above mentioned operations, contact the nearest
After Sales Service Force. The After Sales Service specialist will carry out the reversibility of
the doors at your cost.
A
B
h2
h4
h6
• Unscrew the pin (A) and screw it on the
opposite side.
• Remove the cap (B) and position it on
the opposite side.
• Fit the handle on the opposite side in the
free holes.
• Remove the handle. Unscrew the top
handle bracket from the handle rod (h1).
Unscrew the bottom handle bracket from
the door (h2)
• Unscrew the top handle bracket from the
door (h3).
• Re-screw the handle bracket on the door
(h4). Turn the handle bracket with the
handle and screw them to the door (h5)
and the fitted handle bracket (h6)
• Re-insert the door on the lower hinge
pivot .
• Re-insert the door on the upper hinge
pivot slightly tilting the door.
• Screw the lower hinges.
• Refit the plinth.
• Stand the appliance upright.
39
Installation