Cleaning Instructions - Monstershop Electrostatic Powder Coating Machine Bedienungsanleitung

USER GUIDE

CLEANING INSTRUCTIONS

The Powder Coating Machine must be cleaned on a regular basis to ensure no
contaminants are left in the machine which may affect use, including when changing
powder colour.
After each use:
• Clean the powder pump. This is done by removing the pump from the powder hopper
and tubes and blowing through with clean and dry compressed air. Replace once
completed.
• Clean the powder gun. Remove the gun from its associated tubes. Blow through with
clean and dry compressed air. Wipe the outer plastic of the gun with a clean, dry cloth
or brush. Replace once completed. Please ensure the spray gun is discharged before any
cleaning or maintenance is completed.
• Clean the powder hose. Disconnect the powder hose from the powder pump and spray
gun. Blow through with clean and dry compressed air. For best results, insert a small
piece of packing foam into the tube before blowing with compressed air. This will
dislodge any powder more efficiently. Replace once completed.
• Drain moisture filter. Unscrew from bracket and drain of liquids. Dry with a clean cloth
and replace.
Each week:
• Clean the powder hopper. Disconnect all tubes and attachments from the powder
hopper. Empty any remaining powder into a container and seal. Purge the lid of the
hopper with compressed air and blow through the suction tube with compressed air.
Clean the container and lid with a dry cloth and brush. Reconstruct container.
• Clean the auxiliary air tube. Disconnect from control panel and gun. Blow through with
clean and dry compressed air. Replace once completed.
24015 - Electrostatic Powder Coating Machine
13