Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Kaiser4032
31.07.2001 13:04 Uhr
6. The Test
Index
established
degree of magnification,
the paper used and the f-stop selected
to
work
with.
This
means:
With
unchanged
print
size,
same paper, the once-established
negatives to be printed by merely depressing Start-Key @
The
Kaiser
Automatic
Timer
the
established
Test
Index
time and control the exposure cycle.
As son as• there
is a change
f-stop, the relevant Test Index must be reestablished
dance
with
Section
5 hereof.
To
save
time
and
paper,
Test Index along with the relevant
paper
grade,
new batch of paper,
use.
7. Caution:
Stray light is likely to result
cally at high degrees of magnification
To avoid this condition,
shield the easel properly
light coming in from the safelight.
8. The Time Selector
Switch @ offers two exposure
ranges. With operating
conditions
test
results,
i.e. with
identical
exposure
time is always set up when Test Index I is selected
at Time-Setting Control Knob O and Time Selector Switch 2 is
set to „short".
In contrast,
is obtained
with Test
Index
(long).
9. Replacement
of fuse: First pull Mains Cable Plug of Timer out
of supply mains socket! Then remove Screw Cap @ of Fuse
Receptacle
and replace fuse in normal fashion.
Specification
Data:
Operating
Voltage:
190 — 240 v
Operating
Frequency:
50 — 60 Hz
Switching
Capacity:
max. 500 W
2.5 Amps quick-blow
Fuse
Protection:
Right towards technical
changes reserved.
Seite 9
in this
manner
depends
unchanged
f-stop
and
with
Test Index provides
4032
will
now
—
on
the
basis
— determine
the
proper
exposure
in print
size, paper
grade
in accor-
it is
recommended
to
record
details
such as print size,
and f-stop
for subsequent
in test errors,
and with dense negatives.
against
unchanged and with identical
negatives,
the
shortest
available
the longest available
exposure
14 and Switch
2 set to „extended"
(95 — 130 V)
(50 — 60 Hz)
(max. 500 W)
(5 Amps quick-blow)
9
on the
the
for all
of
or
each
specifi-
the
cycling
time
Werbung
