Maintenance - JUNO JDA 5130 Gebrauchsanweisung

Maintenance

Before performing any maintenance
operation, disconnect the hood from the
electricity.
Metal grease filter
The hood has a metal grease filter.
Its function is to withhold the grease particles
in suspension.
To clean the filter, proceed as follows:
a. Disconnect the hood from the electricity.
b. Pull-out the extractable drawer.
c. Open the grid by turning locks B (Fig. 2).
d. Extract the filter
clamps M (Fig. 7).
The metal grease filter lasts forever and
must be washed at least once a month
either by hand or in the dishwasher (60°C)
with suitable detergents.
Attention! When washed in a dishwasher,
the metal grease filter may discolour.
Let the filter dry without damaging it before
putting it back into place.
Every time you clean the metal grease filter
also clean the grid with suitable detergents
without abrasive.
Carbon filter
This hood can be equipped with a circular
charcoal filter.
The charcoal filter cannot be regenerated or
washed.
The charcoal filter must be replaced
every 4 months.
To dismount the charcoal filter:
a. Disconnect the hood from the electricity.
b. Pull-out the extractable drawer.
c. Open the grid.
d. Turn the filter in the anticlockwise
(Fig. 3).
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the
filters may cause fires. Therefore, we
recommend observing these instructions.
after removing the
Replacing the lamp
a. Disconnect the hood from the electricity.
b. Pull-out the extractable drawer.
c. Remove the inlet grid.
d. Always replace burnout bulbs with olive-
shaped max 40 Watt (E14) bulbs.
e. Refit the inlet grid.
— Before calling for Repair service because
the hood fails to light up, make sure the
bulbs are screwed in tightly.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents.
Never use products containing abrasive.
11