Cordivari Claudia Bedienungsanleitung Seite 23

1
2
b) Setting the program for the "Chrono" mode
- Enter into "Stand-by" mode and press the button [-] at least
3 seconds.
- On the upper part of the display the message "Set" will be
1
displayed
2
- To set the day and time press the button [+] until the bottom
part of the display the message "Prog" is displayed (see picture
below).
- Press the [Prog] button to enter the editing mode
- Now a time sequence can be defined for each day of the week.
The procedure starts with day 1, and the desired sequence can
be configured with the [+] and [-] buttons:
For each hour of the day, it is then possible to assign either the
"Comfort" temperature (full bar indication displayed) by pressing
the [+] button or the "Night" temperature (empty bar) by pressing
the [-] button (see picture below). Press [Prog] to confirm the
entered configuration for day 1, and repeat the same procedure
for the remaining 6 days of the week.
1
2
1
2
Cod. 1910000000048 - nv08
7
6
3 5
4
7
6
3 5
4
7
6
3 4 5
7
6
3 4 5
1 7
2 6
3 5
4
Key lock
It is possible to lock the buttons of the device to avoid
inadvertent modifications of the settings.
Press together the buttons [PROG] for 3 seconds to lock all the
buttons except the [On/Stand-by] button. The key-lock icon is
activated on the display.
To unlock the buttons press again together the [PROG] buttons
for 3 seconds.
The key-lock icon disappears on the display:
1
2 6
3 5
4
1
"Open Window Detection" function
The "Open Window Detection" function enables detecting of an
open window by sensing a sudden decrease of the temperature
in the room. In such a case, the device deactivates the heating
element for a maximum of 30 minutes or until an increase of
the room temperature reveals that the window has been closed.
To activate this function:
- Enter into "Stand-by" mode.
- Press the [+] button for 3 seconds.
- Press the [+] button to activate / deactivate the function
- Press the [Prog] button to commit and return into "Stand-by"
mode.
When this function is enabled, the "Open Window" icon on the
display is lit.
When the device detects that the window is potentially opened,
the "Open Window" icon starts blinking
When the function is disabled the "Open Window" icon is not
shown on the display:
Active function
- 23 -
1 7
2 6
3 5
4
7
7
2 6
3 4 5
1 7
2 6
3 4 5
English