KEYI ClicBot Bedienungsanleitung Seite 73

Connexion
La connexion à hotspot est adaptée aux scènes où il n'y a pas de réseau WiFi ou un
mauvais signal de réseau WiFi.
* Méthode de connexion à hotspot:
1. Glissez du bas vers le haut de l'ecran du module du cerveau principal Brain pour
accéder au menu du système, puis choisissez l'icône de l'équipement, cliquez sur
qui génère le code QR hotspot；
2. Ouvrez CliBot APP, puis sélectionnez . Cliquez sur la "connexion du Brain ", ensuite
, choisissez la " Connexion à hotspot", accédez au mode de connexion du scan;
3. Scannez le code QR de hotspot du module de cerveau principal par la caméra du
module du cerveau principal Brain pour se connecter au réseau de hotspot.
Connexion de hotspot
Cliquez sur le bouton de connexion de hotspot
Brain, puis scannez le code QR généré par celui-ci.
Le module du cerveau principal Scannez le code QR de hotspot pour
génère un code QR de hotspot établir la connexion à hotspot
142
All manuals and user guides at all-guides.com
Informations de sécurité
GB19865-2005、GB6675.1-2014、GB6675.2-2014、
GB6675.3-2014、GB6675.4-2014
This device complies with part 15 of the
FCC Rules. Operation is subject to the
condition that this device does not cause
harmful interference (1) this device may
not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.
Any changes or modifications not If this equipment does cause harmful
expressly approved by the party interference to radio or television
responsible for compliance could void the reception,which can be determined by
user's authority to operate the equipment. turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
NOTE:This equipment has been tested following measures:
and found to comply with the limits for --Reorient or relocate the receiving
a Class B digital device, pursuant to antenna.
Part 15 of the FCC Rules. These limits --Increase the separation between the
are designed to provide reasonable equipment and receiver.
protection against harmful interference in --Connect the equipment into an outlet on
a residential installation. This equipment a circuit different from that to which the
generates, uses and can radiate radio receiver is connected.
frequency energy and, if not installed and --Consult the dealer or an experienced
used in accordance with the instructions, radio/TV technician for help.
may cause harmful interference to radio
communications. However, there is no The device has been evaluated to meet
guarantee that interference will not occur general RF exposure requirement. The
in a particular installation device can be used in portable exposure
condition without restriction.
FCC ID: 2AWR5-KY002
Sécurité et confidentialité
RSS-Gen Issue 4 December 2014"&"CNR-Gen 4e
Décembre 2014:
--English:
This device complies with Industry Canada licence-
exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2)
This device must accept any interference, including
interference that may cause undesired operation of
the device.
--French:
Le présentappareilestconforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts
de licence. L'exploitationestautorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout
brouillageradioélectriquesubi, mêmesi le
brouillageest susceptible d'encompromettre le
fonctionnement.
IC : 26344-KY002
143