Lnb Settings - Samsung PS50B579T6S Bedienungsanleitung

Satellite System Setup
❑
Set the LNB used for receiving broadcasting signal.
Satellite System Setup
N
The PIN input window appears.
N
Before running Auto Store, set Satellite System Setup. Then channel scan is run
N
normally.
LNB Power
„
Enables or disables the power supply for the LNB.
Set whether TV provides power supply of LNB.
This function is for making only one TV can provide power supply when using one LNB connecting to two TVs.

LNB Settings

„
Configures the outdoor equipment
• Satellite : Selects the satellite for receiving digital broadcasts.
• Transponder : Selects a transponder from the list or adds a new transponder.
DiSEqC Mode
• : Selects DiSEqC mode for the selected LNB.
• Lower LNB Oscillators
• Upper LNB Oscillators
• Tone 22 KHz : Selects the 22kHz tone depending on the LNB type. For a universal
LNB it should be Auto.
• Signal Quality : Display the current status of broadcasting signal.
Positioner Settings
„
• Positioner : Enables or disables the positioner control
Positioner Type
• : Sets the positioner type between DiSEqC 1.2 and USALS
(Universal Satellite Automatic Location Sysem).
• User Mode : Sets the position of satellite antenna according to each satellite. If you
store the current position of satellite antenna according to a certain satellite, when
the signal of that satellite is needed, the satellite antenna can be moved to pre-
populated position.
- Satellite : Selects the satellite to set the position for.
- Transponder : Selects a transponder from the list for signal reception.
- Moving Mode : Selects the movement mode between discrete and continuous movement.
Step Size : Adjusts the step size degrees for the antenna rotation. Step Size is available when Moving Mode is set to Step.
-
- Go To Stored Position
- Antenna Position : Adjusts and stores the antenna position for the selected satellite.
- Store Current Position
- Signal Quality : Display the current status of broadcasting signal.
• Installer Mode : Sets the antenna movement limits.
- Limit Position : Selects the direction of the Positioner Limit.
- Antenna Positio n : Adjusts the antenna position for the Positioner Limit by pressing the left or right key.
- Store Current Position
- Go To Zero : Moves the antenna to the reference position.
- Reset Positioner Limit
Reset All settings
„
All satellite settings will be reset to the initial values.
is available when Antenna is set to Satellite.
: Sets the LNB oscillators to a lower frequency.
: Sets the LNB oscillators to a higher frequency.
: Rotates the antenna to the stored satellite position.
: Stores current position as the selected positioner limit.
: Stores the current position as the selected Positioner Limit.
: Allows the antenna to rotate over the full arc.
English - 15
Satellite System Setup
LNB Power : On
LNB Settings
Positioner Settings
Reset All Settings
Move Enter
U E
LNB Settings
Satellite : Astra_19.2E
Transponder : 10743 MHz, H/L
DiSEqC Mode : 2/4
Lower LNB Oscillators : 9750 MHz
Upper LNB Oscillators : 10600 MHz
Tone 22 KHz : Auto
Signal Quality
Move Enter
U E
Positioner Settings
Positioner : On
Positioner Type : DiSEqC 1.2
User Mode
Installer Mode
Enter
E
►
Return
R
►
0
Return
R
►
Return
R